Use and Care Manual

Operator’sManual 32
5.4 Exciter
5.4.1 Check oil level:
1.
Tilt the vibration pl
ate for 10 degree.
2.
Open fill
er bore (25).
3.
The oil level must reach the start of the thread of the filler bore
.
4.
If necessary, pour in Shell Omala oil 100 through filler bore (use funnel 0.
8 l).
5.
Close filler bore. (Tightening to
rque 100 Nm)
5.4.2 Changi
ng the oil:
1.
Open fill
er bore (30).
2.
Tilt vibration plate and keep it tilted until the oil
has run out.
3.
Place vibration plate in horizontal positi
on.
4.
Pour in 0.8 l Shell Omala oil 100 throu
gh the filler bore.
5.
Close filler bore. (Ti
ghtening torque 100 Nm)
Do not pour in too much oil!
Take notice: Please pay attention to the corresponding environmental laws when disposing of
used engine oil. We recommend you carry the oil in a container to a central collecting point for
used oils. Do not pour used engine oil into the garbage nor into the sewer system, waste pipes or
even on the ground.