Use and Care Manual
Operator’sManual 26
Wait until the engine stops before repeating the starting procedure.
NOTICEImproper use can damage the compression lever.
If the engine does not start, proceed as follows before attempting to start again:
1.
Press the compression lever down fully and then pull it up
.
2.
Start the engine agai
n.
4.2 Mechanical oil pressure control
It is necessary to reactivate the mechanical oil pressure control in the following cases:
• After the initial filling - first filling - of the fuel tank or if the tank has run dry.
• In the case of an automatic engine stop due to an inefficient engine oil
supply.
•
After freeing the engine when in presence of extremely low temperatures
.
1.
Fill up fuel ta
nk.
2.
Check engine oil le
vel.
3.
To activate depress hand lever for approx. 5 seconds
.
4.
Hold down pin during approx. 5 seconds in the case of encapsulated engine versions
.
5.
Simultaneously actuate hand lever a few times in the case of engines equipped with fuel
pumps
.
6.
Complete engine. Check to see that encapsulating elements seal correctl
y.
Check oil level every 8 to 15 operating hours in spite of the mechanical oil pressure
control.