Use and Care Manual
Operator’sManual 12
Safety
in the work area
When working with the machine especially pay attention to the following points:
• Electric lines or pipes in
work area.
• Gas lines or water lines in the work area.
Starting the machine
Observe the safety information and warning notices located on the machine and in the
operator's manual.
Never attempt to start a machine that requires maintenance or repairs.
Start the machine as directed in the operator's manual.
Vertical stability
Always ensure that th
e machine is vertically stable and cannot tip over, roll or slide
away.
Proper operator position
Do not leave the proper operator position while operating the machine.
The proper operator position is behind the center pole of the machine.
Leaving the danger area
Injury may be caused by moving machines or flying materials.
Ensure that other persons observe a minimum safety distance of 2 m from the machine.
Caution with movable parts
Keep y
our h
ands, feet and loose clothing away from moving or rotating machine parts.
Parts of your body being pulled in or crushed can cause serious injuries.
Switching off the machine
Swit
c
h off the engine in the following situations:
• Before breaks.
• If you are not using the machine.
Store the machine in such a way that it cannot tilt, fall or slip.
Storage location
After operation, allow the machine to cool and then store it in a sealed-off, clean and dry
location protected against frost and inaccessible to children.
Not using starter sprays
Highly flammable starter sprays pose a fire hazard.
Do not use any starter sprays.
Starter sprays are highly flammable and can cause backfiring and engine damage