TPC400Z Operations Manual

Operator’sManual 13
Vibrat
ions
When manually operated machines are intensively used, long-term damage caused by
vibrations cannot be precluded.
Observe the relevant legal instructions and guidelines to minimize vibration stress.
Details on vibration stress associated with the machine can be found in the chapter
Technical Data.
2.6 Safety
during the operation of vibratory plates
Integrated driving mechanism
Machines with integrated driving mechanism must not be set down or stored on the
transport device. The driving mechanism is only intended for transport.
Belt guard
Never operate the machine without a belt guard.
Exposed belts and belt pulleys are dangerous and can cause serious injuries if they pull in
any part of your body or if parts are ejected.
Danger of falling over
Operate the machine so
that it cannot tip over or fall down from bordered areas, edges
and steps.
Load-carrying capacity of the ground
Keep in mind that the load-carrying capacity of the earth to be compressed or bed can be
greatly reduced by the effects of vibration, for example near slopes.
Avoiding crushing
When operating the machine,
pay particular attention to avoid being squeezed between
the machine and an obstacle. Always look in the direction of travel!
Compacting on slopes
The following points must be observed if you plan to compact inclined surfaces (slopes,
escarpments):
• Always stand above the machine on a sl
ope.
• Start at the bottom of a slope (slopes that can be easily managed in an upward
direction can be safely traveled in a downward direction also).
• Never stand in a position where the machine could possibly fall. A slipping or tipping
machine can cause serious injuries.
Not exceeding the maximum tilt position
• Do not exceed the maximum tilt position (see chapter Technical Data).
• Only operate the machine at maximum tilt for short periods of time.
If you exceed the maximum tilt, the engine lubrication system will fail and thus inevitably
damage important engine parts.