TMD14-BRAVO BACKPACK FOGGER Operations Manual FIND THE HOW TO GUIDE ON 1 YEAR WARRANTY WARNING FOR USE WITH WATER-BASED OR WATERBORNE PRODUCTS ONLY. DO NOT SPRAY SOLVENT BASED OR EXPLOSIVE LIQUIDS. FAILURE TO COMPLY MAY CAUSE SERIOUS BODILY HARM OR DEATH.
TMD14-BRAVO: Assembly 1 www.tomahawk-power.com Remove all parts from your fogger box, including the tool kit bag. Fasten the ribbed tube (A) to the blower elbow. Secure the ribbed tube with a hose clamp to the blower elbow. Attach the connecting pipe (B) and place the water valve underneath the 2nd hose clamp. Tighten the hose clamp to secure the connecting pipe (B) and the water valve. Attach the blower pipe (C) by meeting the raised dimple to the slot guide. Twist to lock.
TMD14-BRAVO: Assembly 2 Attach the fan nozzle (D) to the end of the blower pipe. Secure one end of a clear tube to the base of the fogger’s chemical tank. Wrap the 2nd tube around the blower pipe (C) and attach its end to the fan nozzle (D) www.tomahawk-power.com Slip the throttle handle over the connecting pipe (B) and tighten with the bolt and wing nut. Attach the other end to the back of the water valve and the 2nd tube to the front.
TMD14-BRAVO: Blower Assembly 1 www.tomahawk-power.com Remove all parts from your fogger box, including the tool kit bag. Fasten the ribbed tube (A) to the blower elbow. Secure the ribbed tube with a hose clamp to the blower elbow. Attach the connecting pipe (B) and secure it to the ribbed tube with a hose clamp. Attach the blower pipe (C) by meeting the raised dimple to the slot guide. Twist to lock in place.
TMD14-BRAVO: Blower Assembly 2 Slip the throttle handle over the connecting pipe (B) and tighten with the bolt and wing www.tomahawk-power.com To begin using, add 50:1 Pre Mix Fuel (fuel not included) If already set assembled as a fogger, simnply remove the fan nozzle and clear tube. Attach the other end to the back of the water valve and the 2nd tube to the front.
SAFETY PRECAUTIONS AND WARNINGS Operator Precautions 1. This product emits carbon monoxide, an invisible and odorless toxin. Do not run this product indoors at any time. 2. Always turn engine off before adding fuel to the tank. 3. To avoid electrocution, do not touch the cap of the spark plug or wiring while the engine is on. 4. Do not touch the surface of the muffler and the cylinder while the engine is running. It is extremely hot. Equipment Warnings 1. The TMD14’s 2 stroke engine runs on 50:1 fuel mix.
FUELING This engine is certified to operate on unleaded gasoline and twostroke engine oil at a mix ratio of 50:1. This engine requires a mixture of high-quality gasoline and 2-stroke air cooled engine oil. Use mid-grade unleaded gasoline with a minimum octane rating of 91 and no more than 10% ethanol content. Keep the fuel tank far away from flames or sparks. Do not smoke near fuel. When adding pre-mixed fuel to the engine, use a funnel to avoid spillage.
TMD14-BRAVO: Start Up Guide www.tomahawk-power.com Fill the fuel tank with a 2 Stroke 50:1 Pre Mix Fuel for the optimal engine efficiency. Move the throttle handle to the START position. Move the choke to the UP position To prime the engine, press the carburetor bulb 4-5 times or until fuel runs through the lines. Pull the recoil starter cord until the engine turn over and starts. Once the engine fires up, slowly move the choke to the DOWN position.
Move the water valve to the closed position to stop the flow of liquid pesticide. Figure 1. Move the throttle lever to the position to stop the engine. Figure 2. Move the choke to the closed position. Figure 3.
ADDING CHEMICALS AND ADJUSTING OPTIONS Adding Chemicals Warning- Some chemicals sprayed with the mist blower can contain toxic substances which can lead to serious side effects and injury. 1. Avoid direct contact with chemicals and always follow the instructions of the chemical manufacturer. Always wear the proper clothing and chemical protection 2. It’s important to dilute your chemicals according to the chemical manufacturer’s specifications. Never spray undiluted chemicals. 3.
TECHNICAL SPECIFICATIONS Dimensions Net Weight Tank Capacity Engine Size Engine Speed Engine Power Blower Speed 18’’ x 12’’ x 26’’ 24 lbs 3.7 Gallons (14 Liters) 42cc 6500RPM 1.
MAINTENANCE & TROUBLESHOOTING Maintenance Before fixing your equipment, make sure the engine is turned off and completely cooled down. Spark Plug: PROBLEM CAUSE 1. Spark plug is wet Spark Plug No Spark Ignition coil Good Compression ratio Normal Spark Poor Compression Ratio Carburetor Not Fueling 2. Spark plug is dirty 3. The insulation is damaged 4. Spark gap is off 1. Wrap of wire damaged 2. Insulation of coil bad 3. The wire of coil broken 1. Too much fuel in the cylinder 2.
Engine stops while running: PROBLEM Engine stops suddenly The engine stops slowly CAUSE 1. Wire of plug is loose 2. Piston is broken 3. Plug is dirty 4. Fuel is empty 1. Carburetor is dirty 2. Hoses to tank are clogged 3. Water in the fuel SOLUTION Replace Fix or Replace Clean Add Fuel Clean Clean Replace Fuel Engine is difficult to stop: PROBLEM The engine still runs with the throttle at its lowest position CAUSE SOLUTION 1. The throttle cord has short circuited or carburetor piston is blocked.
