Use And Care Manual

STARTING AND STOPPING YOUR ENGINE
Starting Your Engine:
When starting the engine make sure the engine is fueled and the water tank prepped for
spraying.
1. Push the throttle lever to the on position marked (I).
2. Prime the engine 4-5 times, or until fuel is visibly passing through the fuel lines. See Figure 1.
3. Move the choke to the closed position.
4. Pull the recoil starter until the engine fires.
5. After the engine starts, slowly move the choke to the open position.
6. Let the engine idle for several minutes and then begin operation.
Stopping Your Engine:
1. Move the water valve to the closed position to stop the flow of liquid pesticide.
2. Move the throttle lever to the down position (O) to stop the engine.
3. Move the choke to the closed position.
12