Operations Manual
16 – English
MAINTENANCE
General
Let your 6QOCJCYM2QYGT dealer regularly check the machine and make essential adjustments and repairs.
Maintenance schedule
In the maintenance schedule you can see which parts of your machine that require maintenance, and with which intervals it should
take place. The intervals are calculated based on daily use of the machine, and may differ depending on the rate of usage.
*See instructions in the section "Machine’s safety equipment".
** See instructions in the section "Blades" and "Assembly and settings".
***See instructions in the section "Fuel handling".
Cleaning
External cleaning
• Clean the machine daily by rinsing it with clean water after the work is finished. Keep the handles clean and dry.
• Clean the blade block of any excess concrete build up after each use. Use a heavy-duty hand-held brush or a large paint brush.
• If you have spilled fuel or engine oil on the machine. Wipe off the spill and allow the remaining fuel to evaporate.
• Keep all openings and slots on the saw clean open so air flows freely through the engine compartment to ensure proper cooling.
!
WARNING! The user must only carry out the maintenance and service work described in this Operator's
Manual. More extensive work must be carried out by an authorized service workshop.
The engine should be switched off during operations described in this chapter unless otherwise stated.
Wear personal protective equipment. See instructions under the ”Personal protective equipment” heading.
The life span of the machine can be reduced and the risk of accidents can increase if machine maintenance
is not carried out correctly and if service and/or repairs are not carried out professionally. If you need further
information please contact your nearest service workshop.
Daily maintenance Weekly maintenance/40 hours Monthly maintenance/200 hours
Cleaning
External cleaning Air cleaner Fuel cup
Spark plug
Check
General inspection Drive belt Spark plug and electrode gap
Skid plate
Lexan cover*
Blade block guard*
Blade**
Fuel level***
Oil level
Change
Oil (After the first 20 h then every 100
h)
Air cleaner element
Greasing Blade shaft bearings