Use And Care Manual

SPRAYER CLEANING AND STORAGE

Sprayer Cleaning

Immediately after each use of your Tomahawk Concrete Sprayer it is important to clean it

properly. Fill the solution tank of the sprayer with 2-3 gallons of water. Start the engine and

proceed to spray the water into a waste receptacle. Routine cleaning will help to clean out the

sprayer’s pump, hoses, and spraying attachments – while reducing the chances of the system

clogging.

DO NOT use Xylene or any explosive chemical in the cleaning process. This

concrete sprayer is meant for use with water-based or waterborne compounds

only. Do not spray solvent-based or explosive liquids with this sprayer. Failure

to comply may cause serious bodily harm or death.

Sprayer Storage

For long-term storage of the sprayer, first perform all regular maintenance procedures and

needed repairs. Empty the fuel tank. Disconnect the fuel supply line from the carburetor and

depress the primer bulb until fuel stops discharging from the fuel-return line. Start the engine

and allow it to run until it stops. Pull the starter cord a few times to remove any excess fuel from

the engine. Remove the spark plug and insert a small amount of oil into the cylinder. Slowly pull

the starter cord and bring the piston to a position closest to the spark plug hole. Re-install the

spark plug. Apply a thin coating of oil to all the metal surfaces and store the duster in a dry

place.