User Manual

Checkthatthevoltagestatedonthedevice’sinformaonplatematchesthevoltageusedinyourregion.
TURNING THE VACUUM CLEANER ON
1. Placethevacuumcleaneronadryandleveloor.
2. Pull out the cord by the plug and insert the plug into a power socket.
3. Turnthevacuumcleaneronbypressingtheon/ofootpedal
.
4. Dependingonthetypeofooryouwanttovacuum,youcanadjusttheoornozzle.
Forcleaninghardoors,makesurethebrushesintheoornozzlearedown.
Forcleaningcarpengoracarpet,makesurethatthebrushesintheoornozzleareretracted.
 Whenitishardtomovethebrushoverthesurfaceyoucandecreasethesuconpowerwiththebuontosetthesucon
power min - max or open the the addionalsuconpowercontrolonthehandleofthehose.
TURNING THE VACUUM CLEANER OFF
1. Turnthevacuumcleanerobypressingtheon/ofootpedal
.
2. Unplugthevacuumcleaner,holdtheplugandautomacallyrewindthecordbypressingthecordrewindingfootpedal
. Guide the cord with your hand to prevent possible damage. The power cord will be drawn in the vacuum cleaner.
USE
EN - 16
Checkthehose,dustcollectorandltersregularlytopreventanyproblems.Ifthehoseisclogged,emptyit.Emptythedust
collectorwhenitisfullandcleanorreplacethelterswhentheyaredirty.
EMPTYING THE DUST COLLECTOR
Onthedustcollectoryouwillndamaximumindicaonmaxll[17].Emptythedustcollectorwhentheamountofdirt
reachesthemaximumindicaon.
1. Grabthehandleofthedustcollectorandpressthebuon[4]toreleasethedustcollector.Lithe
dust collector.
2. Holdthehandleofthedustcollectorwhileholdingitaboveadustbin.Pressthebuon[18]to
opentheboomofthedustcollector.Theboomlidopensautomacallyandreleasesthedirtin
the dust bin.
3. To fully empty the dust collector, calmly shake it above the dust bin.
4. Closetheboomlidofthedustcollector.Youwillhearaclickwhentheboomlidisclosed
correctly.
5. Place the dust collector back on the vacuum cleaner. You will hear a click when it is placed correctly.
CLEANING THE CYCLONE FILTER
Theltersplayanimportantpartintheeciencyofthevacuumcleaner.Whentheltersarecloggedtheperformancewill
decrease. Therefore cleaningorreplacingtheltersfrequentlyisessenal.Cleanthecycloneltereverysixmonths.
1. Grabthehandleofthedustcollectorandpressthebuon[4]toreleasethedustcollector.Lithe
dust collector.
2. Pull the clip [19] forwards and open the lid of the dust collector.
3. Pullthecyclonelter[20]outofthelidofthedustcollector.
4. Cleanthecyclonelter[20]underlukewarmwater.Donotuseanycleaningagentsorbrushes.
 Cleaningthelterwillremovethedirt,butwillnotrestoretheoriginalcolorofthelter.Thecolor
ofthelterisnotofanyinuencetotheperformance.
5. Pressamuchwateraspossibleoutofthecyclonelterandletitairdrycompletelyforatleast24
hours.
 Aenon:usingadampcycloneltercouldcausedamagetotheengine.
6. Pressthecyclonelterbackinthelidofthedustcollector.
7. Close the lid of the dust collector. You will hear a click when it is closed correctly.
8. Place the dust collector back on the vacuum cleaner. You will hear a click when it is placed correctly.
MAINTENANCE
20
4
18
17
19