User Manual

MAKING ESPRESSO/COFFEE
Check that the voltage stated on the informaon plate matches the voltage used in your region. Place the coee machine on a
at, stable and heat-resistant surface. Insert the plug in an earthed wall socket.
1. Take the removable water reservoir from the appliance, slide the cover upwards and fold it over.
Fill the water reservoir with cold drinking water. Do not ll it above the MAX mark. Place the cover back on
the reservoir and slide the reservoir back into the appliance.
2. Take the lter holder from the appliance by turning it clockwise.
3. Fill the one- or two-cup lter with the required amount of coee by means of the provided measuring
spoon. Firmly compress the coee using the tamper. Depending on your taste, approximately 1 cup of
coee can be made with 1 measuring spoon. When using coee capsules for making coee, you can place the capsules of
your taste in the lter provided for that purpose. Aenon! Avoid making contact with the blades in the lter for coee
capsules, these are very sharp.
4. Place the lter in the lter holder, making sure that the ball at the side of the lter falls precisely into the indentaon in the
holder. Then place the holder in the appliance from posion
and rmly turn the handle counter-clockwise to posion
.
5. Place the required number of coee cups on the cup grille. Make sure the cups are properly posioned, so that the coee
ows into the cups.
6. Check that the steam controller is switched o (turned upwards). Switch on the appliance by pressing the on/o buon,
aer which the indicator light switches on. The indicator light next to the coee buon is ashing to indicate that the
appliance is being pre-heated. When this light remains on, press the coee buon and the coee will start to ow. Press the
coee buon once more when the required amount of coee has been made. If you do not do this, the cup will overow!
Aenon: Aer making coee, the indicator light may start to ash again to indicate that the appliance is pre-heang. When
the light remains on, you can connue making coee.
7. Coee tastes best immediately aer it has been made, so do not wait too long before serving.
Tips:
• We recommend slightly warming up an espresso cup prior to use, for instance by rst placing it on the hot plate on top of
the appliance. A pre-heated cup will prevent the espresso from cooling down too quickly.
• In order to make a good espresso, we recommend pre-heang the appliance. This is done by rst making a cup of espresso
without adding coee, as a result of which hot water ows through the appliance.
Warning: Do not leave your coee machine unsupervised when it is working, because of the manual acons you have to
perform.
HEATING UP (CHOCOLATE) MILK
Check that the voltage stated on the informaon plate matches the voltage used in your region. Place the coee machine on a
at, stable and heat-resistant surface. Insert the plug in an earthed wall socket.
1. Take the removable water reservoir from the appliance, slide the cover upwards and fold it over.
Fill the water reservoir with cold drinking water. Do not ll it above the MAX mark. Place the cover back on
the reservoir and slide the reservoir back into the appliance.
2. Check that the steam controller is switched o (turned upwards). Switch on the appliance by pressing the
on/o buon, aer which the indicator light switches on. The indicator light next to the coee buon
ashes.
3. Now press the steam buon. The indicator light next to the coee buon switches o and the light next to the steam buon
ashes. When this light remains on, the water is at the right temperature.
4. Turn the steam pipe away from the appliance, use the provided handle for this.
5. Fill a cup with the drink that you want to heat up, (chocolate) milk. It is important that the cup used is not too small, observe
a minimum diameter of 7.5 mm and take into account that the drink can double in volume when foaming.
6. Remove the aachment from the steam pipe and place the steam pipe in the drink to be heated. If you also want to foam
your drink, leave the aachment on the steam pipe. Place the steam pipe in the drink to be warmed up. Make sure that the
end of the steam pipe is always in the drink (approx. 2 cm), and not only in the foam for example, to prevent liquid from
splashing upwards.
EN - 15