User Manual

FROTHING MILK
EN - 12
Remove the plug from the wall socket and allow the milk frother to cool prior to cleaning.
Clean the milk frother aer every use.
Remove the milk jug from the base and remove the whisk or mixer from the milk jug by liing it directly upwards. Rinse the
milk jug with hot water and detergent (if required) to remove all milk residue.
Ensure that no milk residue remains in the milk jug. This is unhygienic and may be harmful to your health. Clean the cover,
silicone ring of the cover, whisk and mixer with warm water and mild detergent. Dry these components thoroughly. The
loose components, the milk jug with lid and the whisk/mixer may be cleaned in the dishwasher.
Neverimmersethepowerbaseinwaterand/orotherliquids.Donotrinseitunderthetap. Regularly wipe the outside
with a damp cloth.
Neverusedetergentsand/orabrasivesorsharpobjectsthatcoulddamagethecoang!
CLEANING AND MAINTENANCE
Check that the voltage corresponds with what is stated on the informaon plate. Insert the plug into the socket.
Place the whisk (with spring) at the boom of the milk jug onto the drive sha. Fill the milk jug with the required quanty of
milk.
Take note of the lower maximum indicaon for frothing milk - MAX
- 150 ml. Frothing milk expands and the milk frother
may overow when using too much milk. The minimum capacity is 100 ml.
Makingwarmfrothedmilk
Place the cover and place the milk jug on the power base.
Press the funcon buon T repeatedly to select the correct funcon / temperature.
  WARMFROTHING- purple indicator light
The colour of the indicator light in the funcon buon corresponds to the selected funcon.
Press the on/o buon to switch on the milk frother. The indicator led in the on/o buon will light and the whisk will start
to turn. Depending on the quanty of milk, the milk frother will stop automacally aer approximately 270 seconds.
Once the milk frother is ready, the indicator led in the on/o buon will turn o.
Makingcoldfrothedmilk
Place the cover and place the milk jug on the power base.
Press the funcon buon T repeatedly to select the correct funcon / temperature.
  COLDFROTHING- blue indicator light
The colour of the indicator light in the funcon buon corresponds to the selected funcon.
Press the on/o buon to switch on the milk frother. The indicator led in the on/o buon will light and the whisk will start
to turn. Depending on the quanty of milk, the milk frother will stop automacally aer approximately 110 seconds.
Once the milk frother is ready, the indicator led in the on/o buon will turn o.
When the milk frother is ready, remove the milk jug from the power base and pour the frothed milk into a mug or cup via
the spout. Remove the plug from the socket aer each use.
Aer use, the milk frother should be cleaned as described in the chapter CLEANING & MAINTENANCE.
Allow the milk frother to cool for 2 minutes before using it again, or pour some cold water into the milk frother. This will
allow it to be used again sooner.
TIPS
• You will get the best milk froth result with full milk.
• If there is too lile milk in the milk frother (less than 100 ml), the result will be poorer.
• The quality of the milk froth may dier signicantly between dierent brands of milk. Experiment with other brands,
if necessary, for a beer result.