User Manual

• Do not use the heang pad when it is folded or crumpled.
• Do not use the heang pad when it is wet.
• Only use this heang pad in combinaon with the switch indicated
on the label.
• Under certain condions, the electric and magnec elds
transmied by this heang pad could aect the operaon of your
pacemaker. However, the radiaon values are far below the limit
values: electric eld strength: max. 5000 V/m, magnec eld
strength: max. 80 A/m, magnec ux density: max. 0.1 millitesla.
Therefore, contact your physician or the manufacturer of your
pacemaker prior to using this heang pad.
• Do not pull the cords, do not twist them and also do not fold them
under sharp angles.
• Regularly check the heang pad for signs of wear and tear or
damage. If there are signs of wear and tear or damage, or if the
heang pad has not been used as intended, or the pad no longer
gets warm, have the heang pad checked by the manufacturer prior
to use.
• Do not open the appliance or repair it yourself under any
circumstances. If you do, a fault-free operaon can no longer be
guaranteed. If you do not observe this instrucon, the warranty will
become invalid.
• If the power cord of the appliance is damaged, it should be
removed. If it is not possible to disconnect the power cord from
the appliance, the enre appliance should be disposed of.
• When this heang pad is switched on,
– no sharp object may be placed on it,
– no heat sources such as hot water boles, heang pads, etc.,
should be placed on it.
• The electronic components in the switch become warm when using
the heang pad. When switched on, the switch may not be covered
or placed on the heang pad.
• Observe the instrucons in the following chapters at all mes:
Operaon, Cleaning and maintenance, Storage.
• If you have any quesons about using our appliance, please contact
our customer service.
EN - 16