User's Manual

6-B Rear Panel Description

①ANT A RF Output Connector. Connect the coax cable to the antenna.

②INPUT RF Input Connector. Connect the coax jumper cable from the

transceiver.

③CONT D-Sub (15pin) Socket. Connect the band data cable to the

transceiver.

④TUNER DIN Socket. Connect the control cable from External Auto

Antenna Tuner, HC-1.5KAT.

⑤ TRXSEL Switch to select the transceiver manufacturer (i.e. ICOM, Yaesu,

Kenwood).

⑥GND Ground Terminal.

⑦⑧FUSE A pair of fuses for AC Mains. 250 V/12 A glass fuse.

(Self extinguish type.)

⑨AC POWER 230 V AC Mains Socket. Socket for the AC power cord. (Socket

is EMI filtered.)

⑩ALC ADJ. Potentiometer to adjust ALC voltage level. Minus 10 V is

available at maximum, when turned full counter-clockwise.

Factory setting is 0 volts, with the pot turned full clockwise.

(See page 16, Section 9. ALC Connection for more details.)

⑪SEND RCA Jack. Connect the control cable from the ACC terminal (or

①

② ③ ④ ⑤

⑥

⑦

⑧

⑨

⑬ ⑫

⑪ ⑩