Operation Manual

CONNECTION & SETTING UP
Installing batteries (backup for the clock in case of a power outage)
- Open the battery compartment on the back of the appliance (17).
- Insert 2 LR3 1.5V batteries, respecting the indicated polarity.
- Close the battery compartment.
INFORMATION ABOUT THE BATTERIES (not supplied)
- The clock must be equipped with the appropriate battery in order to function properly.
- Only the recommended batteries should be used.
- Polarity must be respected when inserting the batteries.
- The batteries should be inserted in such a way as to avoid any short circuit.
- Do not mix used and new batteries.
- Do not mix alkaline, standard (carbon-zinc) and rechargeable (nickel-cadmium) batteries.
- Do not recharge or try to open the batteries. Do not throw the batteries in the fire.
- Replace all batteries at the same time with identical batteries.
- Remove the batteries from the appliance if not used for a long time.
- If the liquid contained in the battery comes in contact with eyes or skin, wash the area immediately and
carefully with clear water and consult a doctor.
- Do not expose batteries to excessive heat such as solar radius, fire or similar.
- WARNING: Danger of explosion if the batteries are not placed properly.
In order to respect the environment, do not throw spent batteries out with household
waste. Dispose of them at your nearest recycling centre or at a used battery collection
point.
Connecting the product
- Install the stand on the top of the sound station.
- Connect the speakers to the sound station by plugging the sockets inside jacks (12) et (13).
- Connect the plug of the mains voltage adaptor into the socket (14). Plug the other end of the mains
adaptor into a mains socket.
- Only use the adaptor supplied. If another adapter is used, first make sure that it has identical
specifications.
PHONES
The system includes a stereo PHONES jack on the front panel of the main unit. You may connect a
set of stereo headphones, not included, to this jack for private listening without others.
The main unit speakers are automatically shut off when headphones are connected to the PHONES
jack. If the plug is not fully inserted the sound may be intermittent or you may hear sound one side
of the headphones.
IMPORTANT: To prevent hearing damage always set the volume control to a low level before you
connect the headphones. Then connect the headphones, put them on, and very gradually increase
the volume to a comfortable listening level.
15