Operation Manual

GB-03
4. Ventilation - The unit should be situated with adequate space around it so that proper heat
ventilation is assured.
Allow 10 cm(4 in.) clearance from the rear and the top of the unit and 5 cm (2 in.) from each side.
- Do not place the unit on a bed, rug, or similar surface that may block the ventilation openings.
- Do not install the unit in a bookcase, cabinet, or airtight rack where ventilation may be impeded.
5. Objects and liquid entry - Take care that objects or liquids do not get inside the unit through the
ventilation openings.
6. Condensation - Moisture may form on the CD Pickup lens when:
- The unit is moved from a cold spot to a warm spot
- the heating system has just been turned on
- the unit is used in a very humid room
- the unit is cooled by an air conditioner
When this unit has condensation inside, it may not function normally. Should this occur, leave the
unit for a few hours, then try to operate again.
Electric Power
1. Power sources - Use on batteries or external DC power supply, as specified in the Operating
Instructions and marked on the unit.
2. External DC power supply
- When disconnecting the DC power cord, pull it out by the DC power plug. Do not pull the cord itself.
- Never handle the DC power plug with wet hands, as this could result in fire or shock.
- Power cords should be firmly secured to avoid being bent, pinched, or walked upon. Pay particular
attention to the cord from the unit to the power socket.
- Avoid overloading DC power plugs and extension cords beyond their capacity, as this could result
in fire or shock.
3. When not in use - Unplug the DC power supply from the DC outlet or remove all the batteries if
the unit will not be used for several months or more. When the cord is plugged in ,a small amount of
current continues to flow to the unit, even when the power is turned off.
D POWER SUPPLY
IMPORTANT
Make sure that function is set to POWER OFF before connecting external DC power supply or inserting
batteries.
CAUTION
Use only the supplied external DC power supply.
Use with other cords may result in the risk of fire.
Using on batteries
Open the lid of the battery compartment on the rear and insert six 1.5 V. C size batteries, not supplied,
with the and marks correctly aligned then close the lid.
To switch from external DC power supply to battery power supply, disconnect the external DC power
supply.
The batteries need to be replaced when:
The radio sound is distorted during operation.
Notes on batteries
• Do not mix different types of batteries or old batteries with new ones.
• Never recharge the batteries, apply heat to them or take them apart.
• Remove dead batteries.
If liquid leaks from the batteries, wipe thoroughly to remove.
E CD OPERATION
CD/MP3 OPERATION
1. Set function switch to CD/MP3 position.
2. Open the disc compartment and place the disc, close the compartment and the disc will start playing
automatically.