Operation Manual

5. COMMON OPERATION

1. To turn the unit on/off.

In power off mode, press any button except RELEASE button to turn on the unit. In power on mode, long press

the POWER button to turn off the unit.

2. To select function mode

Press MODE button to change function mode as follows: -->TUNER -->USB -->CARD -->BT-->AUX.

When there is no media (USB/CARD), that mode will be skipped.

3. To adjust the volume level: rotate VOLUME knob to adjust volume level during playback.

4. To mute or resume sound: press MUTE to cut the sound, press again to resume sound immediately

during playback. To resume the sound immediately, you can also turn VOLUME knob.

5. To set sound mode and menu

1) Sound settings: Press SEL button shortly and repeatedly to select the following modes: VOL (volume),

BASS (without preset DSP), TRE (treble)(without preset DSP), BAL(balance) and FAD (fader) in the

sequence and circulation. In each mode, the waiting time is about 5 seconds, and when the waiting time is over,

it will return to the last display mode. After selecting a sound mode, use volume control to set level of the

selected sound mode.

2) To set menu

: Press SEL button and hold for more than 2 seconds to turn on TA ON/OFF mode, then press

SEL button shortly and repeatedly to select following options :

∗ AF ON/OFF

∗ TA SEEK/TA ALARM

∗ PI SOUND/PI MUTE,

∗ RETUNE L/RETUNE S

∗ MASK DPI/MASK ALL

∗ BEEP ON/BEEP OFF

∗ USER SET (FLAT/CLASSIC/ROCK/POP)

∗ EUROPE/AMERICA

∗ VOL LAST/VOL DEFA

∗ STEREO/MONO (in FM mode)

∗ LOUD OFF/LOUD ON

∗ DX/LOCAL (in FM mode)

∗ CLK ON/CLK OFF

∗ CLK 12/24 mode.

After selecting the desired mode, rotate the VOLUME button to select one setup item of the desired mode.

(1) TA SEEK/TA ALARM:

TA SEEK mode: when newly tuned station does not receive TP information for 5 seconds, the radio retunes to

next station which has not the same station(PI) as the last station, but has the TP information. When TP

information gets lost at the current station for retune time which is set by RETUNE SHORT (60 seconds) or

RETUNE LONG (90 seconds), the radio start to retune to next same PI station. When same PI station is not

received in 1 cyclic search, the radio retunes to next station with TP information.

TA ALARM mode: when this mode is selected, any automatic retune mode is not activated. Only double beep

sound (ALARM) is out-put. When newly tuned station does not have TP information for 5 seconds, beeps are

sounded. When TP information gets lost at the current station for retune time which is set by RETUNE SHORT

(60 seconds) or RETUNE LONG (90 seconds), the radio start to retune to next same PI station. When same PI

station is not received in 1 cyclic search, the radio retunes to next station with TP information. When TP

information gets lost at the current station for retune time, the beep sound is out-putted. When newly tuned

station has no RDS signal, PI SEEK may be suppressed.