Operation Manual

EN-2
B
A
1357
2468
7
48
WIRE CONNECTION
LINE OUT:
RED (RIGHT) WHITE (LEFT)
ANTENNA WIRE: BLUE
FRONT AUX IN
CONNECTOR A
4. MEMORY +12V
7. +12V (TO IGNITION KEY)
8. GROUND
Note: (connector A no. 7) must be connected by car ignition
key in order to avoid that car battery being drained when the
car will be not used for long period.
CONNECTOR B
1. REAR RIGHT SPEAKER (+)
2. REAR RIGHT SPEAKER (-)
3. FRONT RIGHT SPEAKER (+)
4. FRONT RIGHT SPEAKER (-)
5. FRONT LEFT SPEAKER (+)
6. FRONT LEFT SPEAKER (-)
7. REAR LEFT SPEAKER (+)
8. REAR LEFT SPEAKER (-)
Note: If your car does not have ISO connector, you can procure it from any car accessory shop
INSTALLATION
PRECAUTIONS
• Choosethemountinglocationcarefullysothattheunitwillnotinterferewiththenormaldrivingfunctionsof
the driver.
• Avoidinstallingtheunitwhereitwouldbesubjecttohightemperatures,suchasfromdirectsunlightorhot
airfromtheheater,orwhereitwouldbesubjecttodust,dirtorexcessivevibration.
• Useonlythesuppliedmountinghardwareforasafeandsecureinstallation.
• Besuretoremovethefrontpanelbeforeinstallingtheunit.
NOTE:Inclinationangleforcarradioinstallationmustnotexceed30˚otherwisethefrontpanelwillnotopen.
Note: Keep the release key in a safe place as you may need it in future to remove the unit from the car.
TO SUPPORT THE UNIT
53mm
182mm
2
182mm
53mm
3
4
TAP
1
2
1
3
Bend these
claws, if necessary
release screw and
bracket
ANTENNA
CONNECTOR
L (WHITE) R(RED)
LINE OUT
ISO CONNECTOR
BLUETOOTH ANTENNA
CONNECT TO
EXTERNAL MICROPHONE
ANTENNA WIRE (BLUE)
FUSE 10A
10
7
2
3
4
4
4
5
5
6
6
8
9
1
Dashboard
1. UNIT
2. RELEASE CASE
3. DASH BOARD
4. HEX NUT
5. LOCK WASHER
6. PLAIN WASHER
7. CAR BODY
8. REAR SUPPORT STRAP
9. TAPPING SCREW
10. M5 X 15 HEX BOLT