operation manual

ENGINE OPERATION40
7
all parts of the engine. Operating the
engine without warm up shortens the
engine's life.
ENOM00044-0
Engine speeds
Idling speed after warming up.
Remark: In case of cold engine starting,
idling speed is increased about 400 min
-1
(rpm) for several minutes.
ENOM00880-0
Trolling engine speed control
function
If the main switch key is pressed for 1 (one)
second during idling or trolling operation,
engine revolution change.
Each time the main switch key is pressed
in the above manner, engine speed
changes as follows.
Starting
850 min
-1
(rpm)
Ѝ
950 min
-1
(rpm)
ЌࠉࠉࠉࠉࠉЎ
950 min
-1
(rpm)
Ћ
1050 min
-1
(rpm)
Buzzer short sounded one time, when set
to 650 min
-1
(rpm) engine speed, and tells
the lowest engine speed was set.
Buzzer short sounded twice, when set to
950 min
-1
(rpm) engine speed, and tells
the highest engine speed was set.
Reset the engine speed when after engine
restarted and or engine speed is above
3,000 min
-1
(rpm), and then trolling engine
speed to be 850 min
-1
(rpm) as standard.
In addition, this function does not operate
when battery voltage is lower than speci-
fied, set engine idle and trolling engine
speed to 850 min
-1
(rpm) automatically.
ENOM00046-A
ENOW00037-0
Before shifting into forward or reverse,
make sure that boat is properly moored
and outboard motor can be steered fully to
the right and left. Make sure that no swim-
mer(s) is ahead or astern of the boat.
ENOW00038-A
z Attach other end of emergency stop
switch lanyard to the operator's PFD
(Personal Flotation device) or arm and
keep it attached during cruising.
Clutch in (In gear) Clutch off (Out of gear)
850 min
-1
(rpm) 850 min
-1
(rpm)
ENOF00868-0
ON
1 seconds
ENOF00876-0
4. Forward, reverse, and
acceleration
WARNING
WARNING