operation manual

ENGINE OPERATION 39
7
1. Bolt
2. Rubber grommet
3. Insert the knotted end of the starter
rope into the notch in the flywheel and
wind the rope around the flywheel sev-
eral turns clockwise.
4. Tie a loop in the another end of the
emergency starter rope and attach
socket wrench that is included in the
tool kit.
ENOW00860-0
Be sure to keep the harness away from the
rotation parts.
1. Harness
5. Be sure to install the stop switch lock
to the stop switch, and attach the stop
switch lanyard securely to the operator
or to the operator's PFD (Personal Flo-
tation Device.)
6. Set the control lever in the Neutral
position.
7. Pull the starter handle slowly until you
feel engagement, keep pulling till you
feel less resistance. Then pull it quickly.
8. After engine starts, do not reinstall fly-
wheel cover and top cowl.
ENOM00043-A
ENOW00932-0
Be sure to check that cooling water is
coming out of the cooling water check port
during warm up.
Warm the engine at low engine speeds for
about
3 minutes : above 5°C (41°F)
5 minutes at 2000 min
-1
(rpm) : blow 5°C
(41°F)
This allows the lubricating oil to circulate to
CAUTION
2
2
1
ENOF00873-0
ENOF00874-0
3. Warming up the engine
CAUTION
1
ENOF00875-0