Technical data sheet
Table Of Contents
- OWNER’S MANUAL
- GENERAL SAFETY INFORMATION
- SPECIFICATIONS
- PARTS NAME
- LABEL LOCATIONS
- INSTALLATION
- PRE-OPERATING PREPARATIONS
- ENGINE OPERATION
- REMOVING AND CARRYING THE OUTBOARD MOTOR
- ADJUSTMENT
- INSPECTION AND MAINTENANCE
- TROUBLESHOOTING
- TOOL KIT AND SPARE PARTS
- PROPELLER TABLE
- MANUEL DE L'UTILISATEUR
- MANUAL DEL PROPIETARIO
- BENUTZERHANDBUCH
INSPECTION AND MAINTENANCE82
10
4. Inject a sufficient amount of engine oil
through the spark plug holes.
Pull the recoil starter rope several times
to circulate the oil throughout the out-
board motor.
ENOM00106-A
If you moor your boat in cold weather at
temperatures below 0°C (32°F), there is
the danger of remained water freezing in
the cooling water pump, which may dam-
age the pump, impeller, etc. To avoid this
problem, submerge the lower half of the
outboard motor into the water.
ENOM00107-A
ENOW00935-0
Striking the sea bottom or an underwater
object may severely damage the outboard
motor.
Follow the procedure below and consult a
dealer as soon as possible.
1. Stop the engine immediately.
2. Check the control system, gear case,
boat transom etc.
3. Return to the nearest habor slowly and
carefully.
4. Consult a dealer check the outboard
motor before operation again.
6. Cold weather precautions
7. Striking underwater object
CAUTION
ENOF01145-0
0)6&B(85B(1B1ERRN࣮࣌ࢪ㸰㸮㸯㸲ᖺ㸯㸯᭶㸰㸰᪥ࠉᅵ᭙᪥ࠉ༗๓㸯㸯㸲㸲ศ