Technical data sheet
Table Of Contents
- OWNER’S MANUAL
- GENERAL SAFETY INFORMATION
- SPECIFICATIONS
- PARTS NAME
- LABEL LOCATIONS
- INSTALLATION
- PRE-OPERATING PREPARATIONS
- ENGINE OPERATION
- REMOVING AND CARRYING THE OUTBOARD MOTOR
- ADJUSTMENT
- INSPECTION AND MAINTENANCE
- TROUBLESHOOTING
- TOOL KIT AND SPARE PARTS
- PROPELLER TABLE
- MANUEL DE L'UTILISATEUR
- MANUAL DEL PROPIETARIO
- BENUTZERHANDBUCH
INSPECTION AND MAINTENANCE 67
10
*1: Have this handled by your dealer.
ENON00030-0
Note
Your outboard motor should receive careful, and complete inspection at 300 hours. This is the best
time for major maintenance procedures to be carried out.
ENOM00091-A
Engine oil replacement
ENOW00091-0
You may be injured due to high engine tem-
peratures if you fill engine oil just after
stopping. Changing engine oil should be
done after the engine has been cooled.
ENOW00092-A
z Do not overfill engine oil, or engine oil
could leak and/or engine could be dam-
aged. If engine oil level is over upper
limit marks of oil gauge, drain oil to level
lower than upper limit.
z Be sure that outboard motor is in upright
and level position when checking or
changing oil.
z Stop engine immediately if low oil pres-
sure warning lamp is lit or oil leak is
found, or engine could be severely dam-
aged. Consult dealer.
z Wipe off engine oil well immediately if
spilled and dispose of it in accordance
with local fire prevention and environ-
ment protection regulations.
ENOW00090-0
Use of engine oils that do not meet these
requirements will result in reduced engine
life, and other engine problems.
Lower Unit
Propeller
zz
Check for bent blades, damage, wear.
Replace if necessary. (See page 72)
Gear oil
Replace
z
z
Replace
z
Change or replenish-oil and check for
water leaks. (See page 71)
500 mL (16.9
fl.oz.)
Cooling water
inlet
zz
Check clogging
Water pump
*1
z
Replace
z
Check for wear or damage and replace
if necessary
Replace impeller
every 12 months.
Power tilt
*1
zz
Check & replenish oil, manually operate
Warning system
*1
z
Check function
Bolts and Nuts
zz
Retighten
Throttle wire
z
Remote control cable
z
Sliding and Rotating Parts.
Grease Nipples
zz
Apply and pump in grease. (See
page 77)
Outer Equipment
zz
Check for corrosion.
Anode
z
Check for corrosion and deformation.
Replace if
necessary.
Description
Inspection intervals
Inspection procedure Remarks
First 20
hours or 1
month
Every 50
hours or 3
months
Every 100
hours or 6
months
Every 200
hours or 1
year
CAUTION
CAUTION
CAUTION
0)6&B(85B(1B1ERRN࣮࣌ࢪ㸰㸮㸯㸲ᖺ㸯㸯᭶㸰㸰᪥ࠉᅵ᭙᪥ࠉ༗๓㸯㸯㸲㸲ศ