Information Sheet

Sleeve-TITE
™
Sleeve Anchors
Page 2 of 6
Instructions
1. Drill the hole perpendicular to the work surface. To assure full
holding power, do not ream the hole or allow the drill to wobble.
Drill the hole at least 1 anchor diameter deeper than the calculated
embedment depth, but not closer than two anchor diameters to the
bottom surface of the concrete. Through drilling is allowed when
using sleeve anchors in hollow concrete block.
2. Clean the hole using compressed air and a nylon brush. A clean hole
is necessary for proper performance.
3. Drive anchor through the xture into the hole making sure the nut,
or head, rests solidly against the xture. Be sure the anchor is set to
the required embedment depth.
4. Tighten the nut, or head, 3 to 5 turns past the hand-tight position.
NOTE: Always wear safety glasses. Follow drill manufacturer’s instructions. Use only solid
carbide-tipped drill bits meeting ANSI B212.15 diameter standards.
Anchor
Dia.
(in.)
Drill
Dia.
(in.)
Bolt
Dia.
(in.)
Eective
Embed.
Depth (in.)
Min.
Edge
Dist. (in.)
Critical
Edge
Dist. (in.)
Min.
Spacing
Dist. (in.)
Critical
Spacing
Dist. (in.)
1/4 1/4 3/16 1-1/8 1-1/4 3 1-11/16 3-3/8
5/16 5/16 1/4 1-7/16 1-1/2 3-3/4 2-3/16 4-5/16
3/8 3/8 5/16 1-1/2 1-3/4 4-1/2 2-1/4 4-1/2
1/2 1/2 3/8 2-1/4 2-1/4 6 3-3/8 6-3/4
5/8 5/8 1/2 2-3/4 3-1/8 7-1/2 4-1/8 8-1/4
3/4 3/4 5/8 3-3/8 3-3/4 9 5-1/16 10-1/8
1 2
3
4
Installation Information
Length Selection
B
C
Minimum Embedment (hv)
+ Attached Material Thickness (t)
+ Nut Height* (C)
= Total Anchor Length (l)
*Nut height equals anchor
diameter.
Minimum Embedment
Attached Material Thickness
Nut Height = anchor diameter
Total Anchor Length
hv:
t:
C:
l:
Installation Data