Installation & Assembly

.060" - .078"

4E 4F 4G

To Close the gate by

switching the side part

of locking handle to

horizontal position.

distances should be equal

tension nuts

tighten inward

gate frame

tighten inward

Step 4

• Tighten both of the bottom tension nuts 4A by turning them clockwise at the same time 4B.

• Tighten both of the upper tension knobs 4C by turning them clockwise at the same time, so the gap

between the gate and upper right corner comes together, leave a .060" - .078" gap shown in gure 4D.

• Use the wrenches provided to ease turning the tension knobs and nuts. Figure 4E, 4F.

1. Rotate the locking handle to the vertical position.

2. Depress the release button as shown.

3. Lift the door up until it swings freely.

4. Swing the door open in desired direction.

Operation

1. Simply release the gate and allow it to swing closed (unless the Stay-Open feature is used).

To latch, rotate the locking handle to horizontal position, as shown in Figure 5B. This eﬀectively “triple latches” the gate.

Note: Verify proper gate installation by partially opening and releasing it.

The door will swing closed and double-latch automatically.

Opening the gate locking system (see Figure 5A):

Closing and latching the gate (see Figure 5B):

Note: When tightening, the distance between the 4 tension bolts should be equal as shown in gure 4G.

Page 4

(approx. the

width of a nickel)