Installation & Assembly

Page 3
Figure 4
PRESSURE MOUNTING
Pressure Mounted maximum opening size 40” (if
opening is greater than 40” use Door sockets).
STEP 1
Place gate on floor with handle on the opposite side of
area accessible to the child, expand the gate so that all
four bumpers are in contact with sides of the opening.
STEP 2
Rotate locking handle and insert handle tab into the
slot that gives you enough tension to secure the gate.
STEP 3
To release locking handle press down on it lightly, twist
it outwards, and pull gently away from the gate.
PRESSURE MOUNTED USING DOOR
SOCKETS
(On Openings over 40”)
Always use tape pads when using mounting sockets.
Note: Foam tape may leave a foam residue or damage
some wall surfaces when removed. Screws, in
addition to tape, may be used for added security. Four
longer screws are provided in hardware package.
STEP 1
Place tape pads in recessed area of door sockets.
STEP 2
Remove protective cover sheet from one of the door
sockets and with “U” upright, place on a flat, even
surface between 2 ¾” and 4” above the floor. Do the
same on the opposite side. Mount the
remaining two door sockets 20” (measured from the
bottom of the sockets) above the bottom sockets 1 &
2, as shown in Figure 5.
STEP 3
Mount the gate by aligning the four bumpers in the
door sockets and rotating the handle and locking it
into the slot that gives you enough tension to secure
the gate. See Figure 2.
STEP 4
To release the locking handle, press down on it
lightly, twist it outwards, and pull gently away from
the gate.
Figure 1
Figure 2 Figure 3
Figure 5
Figure 6
INSTALLATION AND OPERATING INSTRUCTIONS