User's Manual
Table Of Contents
- Tobii I-Series User’s manual v_1_0_4 - en-US_WEBHQ_102.6.11
- 1 Introduction
- 2 Safety
- 3 Overview of the Tobii I–12 and I–15
- 4 Batteries in the Tobii I-Series
- 5 Using the Tobii I-Series
- 5.1 Starting the Device
- 5.2 Shutting Down the Device
- 5.3 Using Tobii Gaze Interaction
- 5.4 Using Windows Control
- 5.5 Wake the I-Series from Sleep with Gaze Interaction
- 5.6 Pause/Resume Gaze Interaction and Put the I-Series to Sleep with Gaze Interaction
- 5.7 Using the Cameras
- 5.8 Using the GEWA Programmable IR Remote Control
- 5.9 Adjusting the Volume
- 5.10 Adjusting the Sound
- 5.11 Performing a Factory Recovery
- 5.12 Calibrating the Touch Screen
- 6 Configuring the I-Series with the I-Series Control Center
- 7 Tobii Gaze Interaction Settings
- 8 Gaze Selection Settings
- 9 Product Care
- Appendix A Support, Warranty, Training Resources
- Appendix B Compliance Information
- Appendix C Computer Device States of Operation
- Appendix D Maximum Allowed Temperature
- Appendix E Technical Specifications
- Appendix F Approved Accessories
8. Select "Factory Reset” and press the (Enter) keyboard button.
9. The I-Series Software Installation dialogue will be loaded
10. Follow the instructions on the screen. These steps are identical to the initial setup you did when you first received the
device.
The Factory Recovery process will now start. This will take about 40 minutes. After the restore process is finished, the device will
be reset to its original image as it was when you first received it from Tobii. If you have installed any additional Software or Tobii
Product Keys after you ordered the device, these will have to be manually installed again
5.12 Calibrating the Touch Screen
There are two ways of calibrating the Touch Screen depending on if the Windows Control Panel is in Category view or Classic
view with Small/Large icon.
To calibrate the Touch screen from Category View in Windows Control Panel, follow this procedure:
1. Select SSttaarrtt >> CCoonnttrrooll PPaanneell
2. Select HHaarrddwwaarree aanndd SSoouunndd
3. Select TTaabblleett PPCC SSeettttiinnggss
4. Select the CCaalliibbrraattee...... button under Display options
5. Follow the on-screen instructions
To calibrate the Touch screen from Classic View with small/Large icons in Windows Control Panel, follow this procedure:
1. Select SSttaarrtt >> CCoonnttrrooll PPaanneell
2. Select TTaabblleett PPCC SSeettttiinnggss
3. Select the CCaalliibbrraattee...... button under Display options
4. Follow the on-screen instructions
32
5 Using the Tobii I-Series
Tobii I-Series User’s manual v.1.0.4 - en-US