User's Manual
Table Of Contents
- Tobii I-Series User’s manual v_1_0_4 - en-US_WEBHQ_102.6.11
- 1 Introduction
- 2 Safety
- 3 Overview of the Tobii I–12 and I–15
- 4 Batteries in the Tobii I-Series
- 5 Using the Tobii I-Series
- 5.1 Starting the Device
- 5.2 Shutting Down the Device
- 5.3 Using Tobii Gaze Interaction
- 5.4 Using Windows Control
- 5.5 Wake the I-Series from Sleep with Gaze Interaction
- 5.6 Pause/Resume Gaze Interaction and Put the I-Series to Sleep with Gaze Interaction
- 5.7 Using the Cameras
- 5.8 Using the GEWA Programmable IR Remote Control
- 5.9 Adjusting the Volume
- 5.10 Adjusting the Sound
- 5.11 Performing a Factory Recovery
- 5.12 Calibrating the Touch Screen
- 6 Configuring the I-Series with the I-Series Control Center
- 7 Tobii Gaze Interaction Settings
- 8 Gaze Selection Settings
- 9 Product Care
- Appendix A Support, Warranty, Training Resources
- Appendix B Compliance Information
- Appendix C Computer Device States of Operation
- Appendix D Maximum Allowed Temperature
- Appendix E Technical Specifications
- Appendix F Approved Accessories
5.10 Adjusting the Sound
You can configure the built-in speakers using the WWiinnddoowwss 77 CCoonnttrrooll PPaanneell >> HHaarrddwwaarree aanndd SSoouunndd.
We refer to Microsoft’s information on how to configure the sound in the Windows 7 Control Panel.
Sound adjustments can also be done in TToobbiiii CCoommmmuunniiccaattoorr.
5.11 Performing a Factory Recovery
Every I-Series device has a factory image stored on the disk. If you need to restore the device back to its original state, this can
be done by using our OEM Factory Recovery Application.
This will delete any personal data or software installed after the device was delivered.
Factory Recovery means that the device will be reset to the factory mode, without anything installed. In this mode you have to re-
enter your Tobii Product Key and licenses to perform the SW installation you have ordered.
Make sure you’ve connected the Power Supply before you start the process - do not run the device on batteries, as it
might run out of power during the Factory Recovery. In such a scenario, you might have to send the unit back to Tobii
for repair.
To perform a Factory Recovery for your I-Series device, follow this procedure:
1. Backup your personal data such as documents and Tobii Communicator settings etc.
2. Make sure you have the I-Series Product Key available
3. Shut down the device
4. Connect a keyboard
5. Start up device again
6. Hold down the
(Arrow Down) keyboard button continually during startup until you get into “Windows Boot
Manager”
7. Select "Factory Reset” and press the
(Enter) keyboard button.
8. The I-Series Software Installation dialogue will be loaded
9. Follow the instructions on the screen. These steps are identical to the initial setup you did when you first received the
device.
or
To perform a Factory Recovery for your I-Series device, follow this procedure:
1. Backup your personal data such as documents and Tobii Communicator settings etc.
2. Make sure you have the I-Series Product Key available
3. Shut down the device
4. Connect a keyboard
5. Start up device again
6. Hold down the
(F8) keyboard button continually during startup until you get into “Advanced Boot Options”
7. Press the
(Esc) keyboard button to get to the “Windows Boot Manager”
Tobii I-SeriesUser’s manual v.1.0.4 - en-US
5 Using the Tobii I-Series
31