User's Manual
Table Of Contents
- Tobii I-Series User’s manual v_1_0_4 - en-US_WEBHQ_102.6.11
- 1 Introduction
- 2 Safety
- 3 Overview of the Tobii I–12 and I–15
- 4 Batteries in the Tobii I-Series
- 5 Using the Tobii I-Series
- 5.1 Starting the Device
- 5.2 Shutting Down the Device
- 5.3 Using Tobii Gaze Interaction
- 5.4 Using Windows Control
- 5.5 Wake the I-Series from Sleep with Gaze Interaction
- 5.6 Pause/Resume Gaze Interaction and Put the I-Series to Sleep with Gaze Interaction
- 5.7 Using the Cameras
- 5.8 Using the GEWA Programmable IR Remote Control
- 5.9 Adjusting the Volume
- 5.10 Adjusting the Sound
- 5.11 Performing a Factory Recovery
- 5.12 Calibrating the Touch Screen
- 6 Configuring the I-Series with the I-Series Control Center
- 7 Tobii Gaze Interaction Settings
- 8 Gaze Selection Settings
- 9 Product Care
- Appendix A Support, Warranty, Training Resources
- Appendix B Compliance Information
- Appendix C Computer Device States of Operation
- Appendix D Maximum Allowed Temperature
- Appendix E Technical Specifications
- Appendix F Approved Accessories
4.2.1 Checking Charge Level
Click on the battery icon, , in the Notification area to see the remaining charge of the battery, which is installed in the
device.
You may also, at any time, check the status of a battery by pressing the indicator button on the face of the battery. Five LEDs
(light-emitting diodes) will indicate the remaining charge level. For example, three lit LEDs indicate a 60% remaining charge, see
Figure 4.1 Battery with Indicator for Remaining Capacity, page 15
.
When charging, the highest capacity LED indicator will be blinking.
The lowest capacity LED indicator (the "20" LED), will also blink when the indicator button is pressed if the battery’s
capacity has dropped below 10%. So don’t rely upon the blinking of the 20% indicator as a guarantee for charging.
If the batteries have been deeply discharged (this can happen by leaving an empty battery inserted in the I-Series de-
vice without the power adapter connected) you may not see any indication of charging when you reconnect the adapt-
er properly to the I-Series device or the Table Charger. It may take some time (even up to 20 minutes) before you see
an LED indication that any charging is taking place. The battery IS being charged during this duration though it is a re-
covery charge raising the level enough to begin normal charging.
4.3 Inserting and Releasing the Batteries
For safety reasons, the I-Series device is delivered without the batteries inserted. The batteries are delivered only partially
charged. The I-Series device can be used right away. It is nevertheless recommended that the batteries are charged for at least
two hours before using the device.
4.3.1 Inserting the Batteries
To insert the batteries:
1. Insert a battery in the battery compartment.
2. Press the battery until it locks in place. You should hear a click that confirms that the battery is in a locked place.
4.3.2 Releasing the Batteries
If the I-Series is in Upright orientation:
1. Press the battery slide lock to the side.
16
4 Batteries in the Tobii I-Series
Tobii I-Series User’s manual v.1.0.4 - en-US