User's Manual
44
Tobii C-Series User’s Manual
using our OEM Factory Restore Application.
Please note that this will delete any personal data or software installed after
the device was delivered.
The device will be reset to the exact same image it had when it was shipped
from Tobii
To restore the factory settings for your C-Series device, performe the
following procedure:
1. Backup your personal data such as documents and Tobii
Communicator settings etc.
2. Shut down the device
3. Connect a keyboard
4. Start up device again.
5. Press and hold F8 during startup
6. Select “Repair your computer”
7. Select the keyboard layout (language) you want
8. Select “Tobii User” and enter “Tobii” as password (Case Sensistive)
9. Select “OEM Factory Restore Application”
10. Select “Restore”.
11. Now accept the agreements and conrm the restore again with
“Yes”.
The factory restore process will now start. This will take about 30-40
minutes. After the restore process is nished, the device will be reset to
its original image. If you have ordered additional licenses after you ordered
the device, these will have to be input again. Any licenses originally ordered
together with the device will automatically be activated. Also, if the device
was ordered without a CEye module, Tobii Eye Control Suite will have to
be reinstalled if the device is intended to be used with a CEye.
Make sure you’ve connected the power supply before you start the process
- do not run the device on batteries, as it might run out of power during the
factory restore. In such a scenario, you might have to send the unit back to
Tobii for repair.
Chapter 5 Using the Tobii C-Series