User's Manual
Table Of Contents
- 1 Introduction
- 2 Safety
- 3 Overview of the Tobii Dynavox I–12+ and I–15+
- 4 Batteries in the Tobii Dynavox I-Series+
- 5 Using the Tobii Dynavox I-Series+
- 5.1 Starting the Device
- 5.2 Shutting Down the Device
- 5.3 Using Gaze Interaction
- 5.4 Using Windows Control
- 5.5 Wake the Tobii Dynavox I-Series+ from Sleep with Gaze Interaction
- 5.6 Pause/Resume Gaze Interaction and Put the Tobii Dynavox I-Series+ to Sleep with Gaze Interaction
- 5.7 Using the Cameras
- 5.8 Using the GEWA Programmable IR Remote Control
- 5.9 Adjusting the Volume
- 5.10 Adjusting the Sound
- 5.11 Performing a Factory Recovery
- 5.12 Calibrating the Touch Screen
- 6 Configuring the Tobii Dynavox I-Series+ with the I-Series Control Center
- 7 Gaze Interaction Settings
- 8 Gaze Selection Settings
- 9 Product Care
- Appendix A Support, Warranty, Training Resources
- Appendix B Compliance Information
- Appendix C Computer Device States of Operation
- Appendix D Maximum Allowed Temperature
- Appendix E Technical Specifications
- Appendix F Approved Accessories
4 Batteries in the Tobii Dynavox I-Series+
4.1 Batteries
The Tobii Dynavox I-Series+ device has two battery compartments. The batteries are of the same size and capacity for both the
Tobii Dynavox I–12+ and I–15+, see Appendix E Technical Specifications, page 88.
Figure 4.1 Battery with Indicator for Remaining Capacity
4.1.1 Hot Swappable
You can remove/replace one battery without switching off the Tobii Dynavox I-Series+ device, providing that the remaining bat-
tery is sufficiently charged. The remaining battery requires being at least ~10% charged to maintain device operation.
Please allow the Tobii Dynavox I-Series+ device a few seconds to detect the newly inserted battery before removing
the other battery.
4.2 Charging
The batteries shall only be charged using the included adapter, or by using theI-Series Table Charger (not included, separate
purchase required). When the Tobii Dynavox I-Series+ device is shut down and the adapter is plugged in, the charging of com-
pletely discharged batteries may take up to 5 hours. The device can be used while the batteries are being charged, though this
may affect the time a battery takes to reach full capacity.
To be sure that charging takes place in both the Tobii Dynavox I-Series+ device and when using the I-Series Table
Charger, be sure to plug the adaptor into both the wall socket and the device or Charger BEFORE you insert the
batteries.
The batteries will only charge when its capacity is 95% or lower.
The expected battery lifetime is 500 charge/discharge cycles. After that, the capacity of the battery will decrease by about 20%
in usage time.
For battery storage and charging temperatures, see 2 Safety, page 12 .
22
4 Batteries in the Tobii Dynavox I-Series+
Tobii Dynavox I-Series+ User’s manual v.1.0 - en-US