User's Manual

15
8.4. Performing Transmission Output Changeover Switch Settings
Transmissioncanbesetforeitheroftwooutputs:‘H’(10mW)or‘L’(1mW).
Theswitchisfactory-presettothe‘H’position.
Note
Be sure to turn the microphone’s power switch OFF before performing settings.
Step 1. ConrmthatthepowerswitchisturnedOFF,thenremove
the battery compartment cover and battery.
Step 2. Using the supplied screwdriver, set the changeover
switch to the desired transmission output.
Set the switch to the ‘H’ position when using the
microphone in a wide area.
If the same bank and channel are used in close proximity
in adjacent locations, set the switch to the ‘L’ position
to shorten the radio wave transmission range for each
location to minimize interference.
Step 3. Reinsert the battery and securely replace the battery compartment cover.
1
2
1
H L
Screwdriver
(accessory)
Transmission output changeover switch