User's Manual

Table Of Contents

8.2.2. Performing encryption settings

[Switching the Encryption function from OFF to ON]

See also the instruction manual enclosed with the WT-D5800 receiver.

Step 1. Enable the receiver's encryption function.

Step 2. With the battery compartment cover removed, switch ON the

microphonepowerswitchandconrmthattheEncryptionindicator

is unlit.

If the indicator is lit, switch encryption from ON to OFF (see p. 13).

Step 3. Switch OFF the microphone power switch.

Step 4. Switch ON the microphone power switch while holding down the

microphone's Encryption setting switch (continue holding until Step

6).

Conrmthatthemicrophone'sEncryptionindicatorisashing.

An ID number is transmitted while the microphone's Encryption

setting switch is held down.

Step 5. Perform pairing setting at the receiver.

The receiver waits for the microphone’s transmitted ID number for

as long as the Set key is held down. The "RECEIVING" indication

is displayed on the receiver's LCD screen until the ID number is

correctly received.

Step 6. AfterconrmingthattheLCDdisplayhasswitchedtothe"SUCCESS"

indication, release both the microphone's Encryption setting switch

and the receiver's Set key.

Step 7. Conrmthatthemicrophone'sEncryptionindicatorislit.

The encryption setting is now ON.

Notes

•DonotswitchOFFthepowertothemicrophoneorreceiverduringsetting.

•Hold down the microphone's Encryption setting switch and the receiver's Set key until the

"SUCCESS" indication appears on the receiver's LCD screen.

If the microphone's Encryption setting switch or the receiver's Set key is released while the

"RECEIVING" indication is displayed on the receiver's screen, the receiver will not have correctly

received the new ID number, leaving the ID number unchanged from the previous value. To match

the receiver ID number with the microphone ID number, switch OFF the microphone's encryption

setting, then repeat Steps 1 – 7 above.

Tips

•TheIDnumberisupdatedwhentheencryptionisswitchedfromOFFtoONagain.(Theencryption

ON/OFF status and ID number are retained even if the power switch is switched OFF.)

•SettingscanbeperformedregardlessofwhetherthemicrophoneorreceiverEncryptionsetting

switchwasdepressedrst.

•ThereceiverdoesnotoutputaudioduringIDnumbersetting,evenifitreceivesaradiosignalfrom

the microphone.

Unlit

Flashing

Lit