Manual

11. SPECIFICATIONS
Microphone Element Dynamic microphone unit
: Unidirectional
Modulation Frequency modulation
Frequency Range 576 – 865 MHz (576 – 606 MHz and 614 – 698 MHz for USA/Canada)
Channel Selectable 64 channels (the number of channels may differ from country to country.)
RF Carrier Power
Less than 50 mW (Factory preset 10 mW ERP)
Tone Frequency 32.768 kHz
Oscillator PLL synthesized
Maximum Input Level 142 dB SPL
Maximum Deviation ±40 kHz
Audio Frequency Response 80 Hz – 15 kHz
Dynamic Range (AF Circuit)
95 dB or more (with WT-5800)
Battery
AA alkaline dry cell battery
Battery Life
Approx. 10 h (when the alkaline battery is used)
Indicator Power/Battery lamps
Antenna Built-in type
Operating Temperature –10°C to +50°C
(14°F to 122°F) (except battery)
Operating Humidity 30 % to 85 %RH
Finish Dark gray
Dimensions ø48 x 244 mm
(ø1.89" x 9.61")
Weight 340 g
(0.75 lb)
(with battery)
Note: The design and specifications are subject to change without notice for improvement.
• Accessories
Microphone holder (with stand adapter) ............... 1
Screwdriver for setting (housed in the body) ........ 1
Storage case ........................................................ 1
Rolling stopper ..................................................... 1
4
IMPORTANT NOTE: To comply with the FCC RF exposure compliance requirements, no change to the
antenna or the device is permitted. Any change to the antenna or the device could result in the device
exceeding the RF exposure requirements and void user’s authority to operate the device.
License requirement
The term "IC:" before the radio certification number only signifies that Industry Canada Technical
specifications were met. Operation is subject to the following two conditions;
(1) This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de
licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas produire de
brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.