Instruction Manual

24 25
8.4.4. Filter view
Clicking the box in the signal ow causes the Filter view to appear.
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10)
(1) (2)
(11)
[Displayed in tabular form]
Clicking the Table indication button (No. 11) permits the lter control area to be displayed in tabular form.
(3)
(4)
(5)
(6)
(7)
(8)
(9)
(10)
(11)
(1)
(1) Filter control area
(2) Filter point symbol
Select the lter point from the lter point symbol as required.
If you right-click a point on the lter point symbol, the popup menu shown at right is
displayed.
Selecting each of the following lters causes a circle to appear on the lter control
area.
To cancel it, right-click the lter point symbol again and select “Through.” The circle on
the lter control area disappears.
A yellow circle indicates the selected lter point.
: Parametric equalizer (PEQ)
:High-pass lter (HPF)
: Low-pass lter (LPF)
: High shelving lter (High Shelving)
: Low shelving lter (Low Shelving)
: All-pass lter (All Pass)
: Low shelving lter (Low Shelving)
: All-pass lter (All Pass)
You can change the frequency and the gain if you drag the lter point on the lter control area.
When a white circle is displayed on the left side of the lter point, by clicking and dragging the white circle up
and down, the Q value of the selected lter point can be changed.