Owner manual
9
Junction circuit board
Heater
Sunshade
Ter minal block (B)
Goes to cameras.
Ter minal block (A)
Goes to remote control units,
rela
y
boxes or outdoor
p
an/tilt heads.
TB2
1312
NC
CAMERA POWER OUT
VIDEO VIDEO
GND
AC
COM
AC
HOT WIPERDEF
CAMERA
POWER NCZOOMFOCUSIRIS
LENS
COM
1
1
1
CN4
CN3
CN1
1
CN2
CN5
1
CN6
1
TB1
CN7
1
CCH200 チュウケイキバン
OUT
VIDEO VIDEO
GND
1234567891011
CN8
1
Terminal Block
When directly connecting to the
remote control units and relay boxes
When using the C-PH200 Outdoor
Pan/Tilt Head
No. ApplicationIndication C-CH200
C-CH200FH C-CH210FH
C-CH200
C-CH200FH C-CH210FH
1
24VAC input (common)AC COM
OO
2
24VAC inputAC HOT
OO
3
Camera power 24 VAC
CAMERA POWER
4
DefrosterDEF
5
WiperWIPER
6
Not connected (unused)NC
7
Lens commonLENS COM
8
IrisIRIS
9
FocusFOCUS
10
ZoomZOOM
11
Not connected (unused)NC
12
Video output (coaxial shield)VIDEO GND
OOO
13
Video output (coaxial core)VIDEO OUT
OOO
Connect the housing cable
supplied with the C-PH200 to
each terminal.
Note
The number of the housing
cable lead wire matches the
terminal number the lead wire
is connected to.
7. CABLE WIRING
7.1. External Control Cable and Housing Terminal Block Wiring
CAUTION
• Keep wiring as far away as possible from a heater. (C-
CH200FH and C-CH210FH only.) Failure to do so may
cause a fire or electric shock.
• Do not touch a heater because fingers may be burned.
(C-CH200FH and C-CH210FH only.)
• Be sure to use the optional CC-5941B 24 VAC adapter
for the 24 VAC power supply. Using adapters other than
the dedicated type could lead to a fire.
Note: Make sure that the power is switched ON after wiring completion.
The junction circuit board shown at
right is exposed if the sunshade is
opened.
Note
Do not connect the AC input to the
Video output. If connected by
mistake, the camera will fail.
Terminal block (A) is set as shown in the following
table. Perform wiring by selecting combinations of
equipment to be used.
*
1
It is convenient to make a connection by way of Terminal block (B) when using the 24 VA camera.
*
2
Connect when using a zoom lens. When using an auto-iris motorized zoom lens, terminal 8 (IRIS) is not
used.
O
O
O
*
1
O
*
1
O
*
1
O
*
1
O
*
2
O
*
2
O
*
2
O
*
2
O
*
2
O
*
2
O
*
2
O
*
2
O
*
2
O
*
2
O
*
2
O
*
2