Cassette Player User Manual

5.2. Track Sequence Selection [BA-800, BA-806 and BA-823]
When both cassette player units (TAPE 1 and 2) are used, the tapes can be played back in order of side A-A-B-B
or A-B-A-B, which is selectable by means of the track sequence selection switch.
(1) Alternate A-A-B-B Playback
With the track sequence switch set to A-A-B-B position, both cassette player units first play back side A of their
respective tapes, and then side B, starting with TAPE 1. This is repeated between both cassette player units in the
following sequence:
(2) Alternate A-B-A-B Playback
If the track sequence selection switch is set to A-B-A-B position, both cassette player units alternately play back
both sides (A and B) of their respective tapes before they are switched to each other.
[Note]: (1) Side A of the tape mentioned above refers to the side to play first. Therefore, it is not the same as
that which is shown on the tape.
(2 ) Be sure to set the link switch to OFF when using a BA-800 (BA-806 or BA-823) individually.
If set to ON, the tape stops after TAPE 2 playback is finished.
START
Side A of TAPE 1
Side B of TAPE 1
Side A of TAPE 2
Side B of TAPE 2
— 20 —