User's Manual

- 6 -
IMPORTANT NOTE
This device complies with FCC radiation exposure limits set forth for an uncontrolled environment. This
device should be installed and must not be co-located or operating in conjunction with any other antenna
or transmitter.
This device is intended only for OEM integrators under the following conditions:
1) This module may not be co-located with any other transmitters or antennas.
2) The antenna must be installed such that 20cm is maintained between the antenna and users.
As long as 2 conditions above are met, further transmitter test will not be required. However, the OEM
integrator is still responsible for testing their end-product for any additional compliance requirements with
this module installed.
In the event that these conditions cannot be met, then the FCC authorizations are no longer considered
valid and the FCC ID cannot be used on the final product. In these circumstances, the OEM integrator will
be responsible for re-evaluating the end product including this module and obtaining separate FCC
authorizations.
[MEMO]