Operation Manual

CHAPTER 2: Operaon
Adjusng Volume
Press the + and - side buons to adjust the volume. Press for 1 second to reach the
maximum or minimum volume level. (15 is the maximum).
Receive only Mode
Press the RCV buon to switch to receive only mode. This mode only receives Laser,
and does not jam. Pressing the RCV buon again will enable Auto sleep mode.
Auto/Quiet
Pressing one second enables Auto sleep mode, this stops jamming funcon aer
4 seconds. Auto sleep mode will take 1 minute to relay back to 4 second jamming
from RCV only mode. Use cauon for 1 minute because laser alerts will be muted
unl the CPU announces “Auto sleep mode o”. Press the SLP/RPT buon for 1
second to report police to the server. ”Test mode” is recommended only for tesng
the jamming capability.
The RDT port is for radar detector integraon, or other accessories. The side PWR
port can be used to power the unit with a 12v barrel connector 1.3 mm.
App operaon
1. Start the Laser defender App. Don’t set up BT connecon through the phone or
tablet operaon system. Press Start/On the buon on the app. (α-15 CPU needs
to be powered on and nearby for connecon).
2. Choose MAC address starng with “1E:03” for Android system, and “1E:04” for
iOS. Password is “1234” or “0000” It should take 15 seconds for seng up.
3. Now you can hide the app, and only keep the pop-up. It automacally
disconnects or re-connects to the α-15 CPU when you switch the α-15 CPU o or
on. To bring the interface back, press the pop-up.
4. CPU automacally reports to the server when it receives laser signals. If you keep
the interface on, you can manually report a few dierent types of spots. If you
manually report from the CPU (by long pressing SLP/RPT buon), it’s police spot.
Any report will be kept on the server for 3 hours.
5. Map view and instrucons are on the upper right corner.
Algorithm update (Must have Internet access)
1. Make sure your App is connected with the Bluetooth, otherwise go through step
1 and 2 in previous paragraph.
2. Press the UDT buon on the CPU (An audio voice will say “Algorithm update/
Open app and choose new algorithm and enable Bluetooth”).
3. Press the UDT buon tab on the App. (You may hear an audio voice, that says
“Start Transferring”).
4. Follow the instrucon on the screen.
5. Choose the newest algorithm version to download and choose to start
transferring.
6. When the le is nished, an audio voice will say “Update nished or aborted/
returning to defender mode”.
a-15
Power
Receive only
Algorithm update
For factory use only
System reset
Auto sleep/Report
Switches to determine heads 3 and 4 or rear.
TP (Terminal Ports 1-4 are connecons for Transponders)
(Heads 1 and 2 are always front.)
Align pins on the transponder cable
with the connecon port
AUTO/QUIETRCV UDT
RST
PWR TP1 TP2 TP3
RER
FRT
TP4 RDT
DTA PWR
1 2
ON
Power port (1.35 mm)
TP4
RDT
6 7