User's Manual

ManualsBrandsTM Performance ManualsAutomobileTM Performance TM motorcycle 2008

ENGLISH

WARNING

REPLACE THE FIBREGLASS CARTRIDGE WITH A NEW ONE OF THE SAME WEIGHT

OR BOUGHT AT A TM AUTHORISED DEALER.

CLEANING CLEANING

CLEANING

THE THE

THE

AIR FILAIR FIL

AIR FIL

TERTER

TER

A dirty air filter jeopardises the filtering of air, reducing engine power

and increasing fuel consumption. In some cases, the dust can even

reach the engine causing derious damage. For this reason, mainte-

nance of the filter should be carried out regularly.

Remove the seat to access the filter and lift the battery holder.

To remove the filter, unscrew the finger screw positioned at the centre

of the filter and carefully slide it the filter out of its case.

WARNING

- DO NOT CLEAN THE FOAM FILTER WITH FUEL OR KEROSENE, WHICH CAN

CORRODE IT. FOR CORRECT MAINTENANCE OF THE FOAM FILTER, USE THE

RELEVANT PRODUCTS ON THE MARKET FOR CLEANING AND LUBRICATION.

- NEVER START-UP THE MOTORCYCLE WITHOUT THE AIR FILTER. THE

INFILTRATION OF DUST AND DIRT CAN CAUSE DAMAGE AND INCREASE

WEAR.

Wash the filter carefully using a special liquid detergent and dry well:

squeeze the filter slightly but do not wring it. Also clean the filter case

and check that the rubber manifold that connects the carburetor to the

filter case is integral and positioned correctly.

Remount the air filter, positioning it correctly on the rest surface, taking

care that edges of the filter are not raised or not adherent with the rest

surface.

Rescrew the finger screw and tighten it adequately.

CHECK HAND DECOMPRESSOR CHECK HAND DECOMPRESSOR

CHECK HAND DECOMPRESSOR

ADJUSTADJUST

ADJUST

(A) (A)

(A)

(ALL 530 AND 660 CC. MODELS)(ALL 530 AND 660 CC. MODELS)

(ALL 530 AND 660 CC. MODELS)

Take the crankshaft to the TDC with closed valves and activate the

hand decompressor. A free play of about 5mm. must be perceived on

the end of the lever. The end of the free play is recognised by the

hardening of the lever that starts to open the right exhaust valve. Adjust

the free play if necessary. To adjust: push the protective hood

backwards, loosen the counter-nut (1) and loosen or unscrew the

adjustment screw (2). Tighten the counter-nut and replace the protective

hood.

WARNING

IF THERE IS NO FREE PLAY ON THE DECOMPRESSION LEVER, THE ENGINE

COULD BE DAMAGED.

INDICATION:

The automatic decompressor does not require adjustment.

FRAME AND ENGINE MAINTENANCEFRAME AND ENGINE MAINTENANCE

FRAME AND ENGINE MAINTENANCE

FRAME AND ENGINE MAINTENANCEFRAME AND ENGINE MAINTENANCE

FRAME AND ENGINE MAINTENANCE