User's Manual

ManualsBrandsTM Performance ManualsAutomobileTM Performance TM motorcycle 2008

ENGLISH

PROGRAMMING THE CLOCKPROGRAMMING THE CLOCK

PROGRAMMING THE CLOCK

(END/SMR/SMM)(END/SMR/SMM)

(END/SMR/SMM)

Remove the connector positioned on the back of the instrument.

Select the CLK function on the display by pressing the right hand button

(blue).

Press the grey button on the rear of the instrument for 5 secs.and “CLK”

(Clock) will start to flash on the display together with the hours.

Press the left hand button (yellow) to set the hour (on 24 hours).

Press the right hand button (blue) again to make the tens of minutes

flash, press the left hand button (yellow) to set the tens of minutes.

Repeat to set the minutes.

End by pressing the grey button on the rear of the instrument for 1 sec.

SETTING SETTING

SETTING

THE DISTTHE DIST

THE DIST

ANCE ANCE

ANCE

TRATRA

TRA

VELLEDVELLED

VELLED

(END/SMR/SMM) (END/SMR/SMM)

(END/SMR/SMM) (only after battery replacement)

The value of the distance travelled must only be re-inserted if the battery

has been replaced.

Five zeroes appear in the display, of which the first is flashing along

with DST, which is also flashing.

Press the right hand button (blue) to make the first of the four numbers

to be set flash and press the left hand button (yellow) to set the desired

value.

Repeat the operation until all of the numbers have been set as desired.

End by pressing the grey button on the rear of the instrument for 1 sec.

ELECTRELECTR

ELECTR

ONIC DIGITONIC DIGIT

ONIC DIGIT

AL BAL B

AL B

CKLIT DISPLACKLIT DISPLA

CKLIT DISPLA

CHOMETER (OPTIONCHOMETER (OPTION

CHOMETER (OPTION

AL FOR END/ SMR/SMM)AL FOR END/ SMR/SMM)

AL FOR END/ SMR/SMM)

As an option to the standard instrument, on the models fit with battery

and Electric Start, you may find the Tachometer/Odometer shown in

Fig. 1. It has a wide backlit display and four pilot lights.

In the top there are the left indicator pilot light (2) , the low beam pilot

light (3), the high beam pilot light (4) and the right indicator pilot light

(5).

Inside the display you find the tachometer (6), the trip odometer (7) and

the total kilometers odometer (8).

In the bottom there are two buttons, “SET” (9) and “MODE” (10).

The instrument unit is the Kmh but it can be easily changed in Mph in

the following way: press and hold the “SET” button, while holding it

press once the “MODE” button.

Repeat the same operation to switch back to Kmh.

The trip odometer can be reset pressing the “SET” button once.

The total kilometres odometer resets automatically when reaching the

limit of 99999 Km or Miles.

The instrument switches on automatically when pressing and posi-

tioning outwards the red button located near the throttle command and

switches off when pressing and positioning inwards the red button

itself.

OPERAOPERA

OPERA

TING CONTRTING CONTR

TING CONTR

OLSOLS

OLS

OPERAOPERA

OPERA

TING CONTRTING CONTR

TING CONTR

OLSOLS

OLS