User's Manual

TK Home Solutions B.V. User’s manual S100 Call module
Reference: 012 – 1122596 Call module user manual partially page 6 of 6
Version: A.1
State: Unreleased
1.4 Accepting incoming calls
The landline is connected to the Call module. An incoming call can therefore
also be accepted while using the stairlift.
When there is an incoming call, the Call module produces a ring tone.
Accepting the call is done as follows:
1. Briefly press the yellow alarm button once. The connection is now established.
Speak in the direction of the alarm button to communicate. The call can be
ended by pressing the yellow alarm button for 1 second.
1.5 Error codes CM
LED colour
Sound
Cause
Off
None
Standby mode
Flashing red
None
Module is not registered to
a base station
Flashing red
Single beep every 20
seconds
Module cannot find the
base station it is registered
to (either because it is out
of range or because the
base station has been
disconnected)
Constant green
Dialling tone
Trying to establish a call
Flashing green
Busy tone
The far-end caller has
disconnected the call
Constant green (after
initiating a call attempt)
None
There is no telephone line
connected to the base
station
For other questions, please contact your supplier.