Instructions / Assembly

FP35094REV1.0

SAFETY INFORMATION

USING YOUR FIRE TABLE/ COLUMN

Before each use, inspect the Gas Hose. Replace Gas Hose. if there are any

signs of cutting, wear or abrasion.

Before you light your Fire Table/ Column, please proceed / adopt the following

steps :

1. Make sure the Control Knob is in the "OFF" position.

2. Open the Door and slowly open the Valve on the Propane Gas Tank by

turning the Contol Knob counterclockwise.

3. Close the Door on the Main Frame of the Fire Table / Column.

4. Push and hold in the Electronic lgnitor to create sparks within the electrode

continue to hold.

5. Push in the Control Knob and turn to the "LOW" position.

Keep holding down the Control Knob to allow gas to ow for 15 seconds.

6. If ignition doesn't occur within a few seconds release the Control Knob and

rotate to the "OFF" position.

Wait for 5 minutes for gas to clear and then repeat the above lighting

instructions.

7. Once the Fire Table/ Column is lit, the ame intensity may be controlled by

turning the Control Knob between the "LOW" and "HIGH" positions.

8. Instructions on properly locating the gas hose including locating the hose out

of pathways where people may trip over it or in areas where the hose may be

subject to accidental damage.

9. Observe ame height when lit:

9.1.) Flame color should be yellow/ blue.

9.2. ) Flame height burns at 2 - 10 inches high.

To Shut Down your Fire Table/ Column, please proceed/ adopt the following steps :

1. Turn Control Knob clockwise to the "OFF" position.

2. Close the Cylinder Valve on the Propane Gas tank if you DO NOT intend to use it

for a long time.

SAFETY INFORMATION: TO SHUT DOWN YOUR

FIRE TABLE/ COLUMN