Install Instructions

4
SENSING TUBE INSTALLATION
DIAGRAM B
MULTIPLE DRYERS, KITCHEN OR BATH FANS
EXHAUSTED INTO A COMMON VERTICAL
CHASE
The sensing tube should be installed to sample the
chase pressure at a point below the lowest duct
connection but above any point in the clean out that
may accumulate moisture or lint. If sampling pres-
sure in the side of a chase, the sensing tube end
should be flush to the interior wall of the chase,
(See Diagram B). Duct connections should be
sealed to prevent leakage or entrainment of air.
Installer must provide access for lint clean out.
Chase Exhaust for Kitchens & Baths or Dryers with RT-Series & COP2
Dryers Common Vented Vertically with RT-Series Inducer & COP2