User guide

REV. 2, 11/96

P/N 8504049

HSUL CONNECTED TO 24V ELECTRONIC IGNITION HSUL CONNECTED TO 24V STANDING PILOT

HST CONNECTED TO 24V ELECTRONIC IGNITION

HST CONNECTED TO 24V STANDING PILOT

HST CONNECTED TO AN R8184G

BURNER MOTOR LESS THAN 3 AMPS @ 120 VAC

TYPICAL HS-SERIES POWER VENTER GAS WIRING DIAGRAMS

TYPICAL HST-SERIES OIL WIRING DIAGRAM

NOTE

IF YOUR ELECTRICAL DIAGRAM IS NOT

INCLUDED, CONTACT OUR CUSTOMER

SERVICE TOLL FREE AT 1-800-255-4208,

7:30 TO 4:30 CST FOR FURTHER

ASSISTANCE.

SERVICE

Specific instructions cannot be made con-

cerning frequency of lubrication. Usually oil-

ing every 3 months during the heating sea-

son will be sufficient. NO MORE THAN 3

DROPS of SAE 20 oil should be used. Oil

holes or lances are provided at the front and

rear faces of motor.