User's Manual

- 29 -
User’s manual_v01
3.4 Mounting and Installation
Locating Donor antenna
 Please install the donor antenna in the previously selected location. Choose a mount type for the
donor antenna that suits your preferences and the environmental conditions.
 You may need to re-locate or rotate the donor antenna in order to find the best direction providing
the strongest signal strength.
Mounting PSR
 Verify that PSR and mounting hole are in good condition
 Place PSR mounting bracket template up against the wall and mark off mount holes
 Drill the appropriate size holes and install the included wall anchors
 Remove the wall mount bracket from the repeater and bolt the wall mount bracket to the wall
 Place the repeater onto the wall mount bracket and secure the bracket to the repeater
 Connect the GND cable
Routing the Cable
 Route the cable between the donor antenna and the repeater unit.
 Ensure that all connections are tightly fastened.
 Ensure that the cable is fastened on the wall or to a cable tray, and secure the connectors to avoid
water decay of the cables.
 Connect the cable to the connector marked ‘DONOR’ on PSR and the other end to the service
antenna.
Locating Service antenna
 Please install service antenna(s) in the previously selected location(s).
 Route the cable between the repeater unit and the service antenna.
 Ensure that all connections are tightly fastened.
 Ensure that the cable is fastened on the wall or to a cable tray, and secure the connectors to avoid
water decay of the cables.
 In the case of multiple service antennas, use appropriate power splitters to split the signal.
 Route the cable accordingly.
 Connect the cable to the connector marked ‘SERVICE’ on PSR and the other end to the service
antenna.
Connecting power cable
 Connect the power cable of the adaptor to PSR where it is marked ‘AC INPUT’ and plug the adaptor
into the power plug.
 Turn the ac power switch ON.