Extra Information

3
2. Setting Up Wi-Fi and Wi-Fi Access Point
Setting up the Wi-Fi and AP (Access Point) is the single most important factor that
determines overall streaming performance.
1) Please SETUP Wi-Fi ACCESS POINT to 802.11n mode only.
- This is the most important and it will remove many potential streaming problems
between SERVER and Tizzbird N1.
- Normally Wi-Fi access point is set to 802.11b/g/.n mode, and it will prevent Tizzbird N1
from maximum connection speed. The legacy Wi-Fi devices such as older model
notebook, smart phone will try to connect Wi-Fi by 802.11g then the speed of Wi-Fi is
confined to 802.11g.
- Please refer to Wi-Fi Access Point manual to change the 802.11n mode only. Normally
it’s possible thru web-browser. The access point normally provides configuration page
thru WEB. For example open the browser and type the http://192.168.1.0 “ will pop up
the configure window of access point.
- If you still want to use Wi-Fi access point on other legacy 802.11g devices, GO GET NEW
ACCESS POINT for streaming purpose only. It’s quite cheap and only $20 or so. Please
don’t try share the ACCESS POINT with other legacy devices. It will ruin
everything. Please don’t complain to us when using N1 with other legacy 11g devices.
There’s nothing much we can do here.
2) Check up the connection speed by “Settings” > “Network” at Tizzbird as following figure. The
“Wi-Fi Setting” item shows the current connection speed. It should be more than 54
mbps. The 54 mbps means it’s connected with 802.11g mode. The best is 150mbps
connection speed.
3) Install the Wi-Fi access point as close as possible with Tizzbird N1. The access point should
reside at direct seeing position where N1 resides at least.