Operation Manual

2) As soon as you turn on power, press <RED> button on remote twice within 3 seconds. The

following screen will come out (Require

revision 2.0.6

or later firmware)

3) There are four menus.

If you want to factory reset status, then select “wipe data/ factory reset”. This will help

the situation when some applications you installed cause a problem.

4) Apply “wipe cache partition” first.

5) To make the device reboot again with fresh image, put the USB flash drive on the USB port,

then select “apply update from /usb”. Please make sure that you have update.zip on the

USB drive.