Operation Manual

ManualsBrandsTivoli ManualsAudioMODEL 10 PLUS Stereo

9 – ENGLISH

stereo output to record the audio. The primary speaker will not be muted when using this

output. This jack accepts a 3.5mm stereo male mini connector.

8. MIX IN: Connect the audio output of another device, such as a computer, to this input to hear

the audio mixed in with the tuner. With the Model 10+ in Auxiliary mode, this input acts as a

second Auxiliary input. This stereo input accepts a 3.5mm stereo male mini connector. The vol-

ume level is controlled by the source device.

9. AUX IN: To hear audio from another device, such as Tivoli Audio’s Model CD, a MP3 player, or

TV, connect said device’s audio output to this stereo input and change the source to Auxiliary.

This stereo input accepts a 3.5mm stereo male mini connector. Note you may need to adjust

the volume level differently for an auxiliary device than the level used for radio listening.

10. SERVICE: The port underneath this label is for use during service only. Do not remove the

“Service” label. Do not connect anything to this port or you could damage the Model 10+ and

void your warranty.

11. POWER CORD INPUT: Firmly insert the included power cord. When unplugging the power

cord from the wall outlet, always grasp it by the plug and not the cord. We recommend the

use of a power strip with surge protection. Be sure your region’s voltage is consistant with the

voltage indicated on the rear panel under the power cord input. Tivoli Audio is not responsible

for damages caused by incorrect voltage.

GUIDE TO FEATURES (REMOTE CONTROL)

1. POWER: Press brieﬂy to power the

Model 10+ off or on. The radio will

power on to the last source used.

2. MUTE/SNOOZE: Press to mute the audio

(the volume bars will disappear from the

icon) while the unit is playing; press again

or adjust the volume to restore sound.

Press to mute the alarm for 7 minutes

after the alarm sounds. A icon will

show on the display when Snooze is ac-

tive. The Snooze time is not adjustable.

3. ALARM: With the Model 10+ powered on,

use the pq and Select buttons to adjust

and set the alarms. For a complete step-

by-step guide, refer to the section titled

“How to set the Alarm.”

4. SLEEP: Press repeatedly to view the

amount of time the radio will play before

it turns off automatically, and press the

Select button to select that time. When

the sleep timer is active you can check

the remaining time by means of pressing Sleep on remote. A small clock face [ ] will show

on the display when the Sleep timer is active. To cancel Sleep, press the Sleep button until

the display shows “Off”.

5. SOURCE: Press repeatedly to change sources.

6. INFO: Press repeatedly to cycle through the information available depending on the source

mode you are in. This function will not work in Auxiliary mode.

MONO

BAC K