Installation Guide

www.tivolilighting.com tel: [phone] fax: [phone]
TW TRACE™ Horizontal Installation Instructions
7101011
Page 2 of 8
Copyright © 2022 Tivoli 08.08.22
Overview: Read Before Installing Luminaire
Installation Notes:
Step 1: Measure run area where Trace™ TW is to be installed. Locate
power feed end at highest point of the run to minimize exposure to
water run off.
Step 2: A Mounting Channel is recommended for outdoor
applications. Lay channel along desired area and attach with screws
(by others) every 18 to 24 inches. If the design requires creating
bends and arcs, it is recommended that the Horizontal Notched
Channel be used. Mounting Clips are for use on indoor applications
only.
Note: Minimum bending diameter for the notched channel is 11”.
Trace™ Horizontal must not be bent less than 2” diameter or damage
will result.
Step 3: Trace™ must be installed with two people. One to press
the luminaire into the channel and the other to hold the spool and
unroll it while keeping the Trace™ flex body straight.
Warning: Risk of Product damage.
Do not stretch, pull, or yank. Doing so can damage the Trace™
internal connections and void the warranty.
Step 4: The Power Feed Connectors and End cap will overhang
outside the ends of the Channel. Measure length of Trace Run and
cut 2.25” off the length of the mounting channel. Insert Trace™ into
mounted channel starting from power connector end. Trace™
should be pressed into the channel carefully and gradually, without
excessive bending or damage will result.
Note: We recommend using a dry spray lubricant, such as 3M Spray
Lubricant or WD-40 Specialist for all Trace™ installations to insure
the luminaire fits into the channel without damage. Additionally,
when installing with Mounting Clips, Silicone Sealant (FLXD-SIL-
GE-10) may be applied to the inside bottom surface.
Step 5: Secure power connection to building with use of C-clamp
(by others) or mount connection inside J-Box.
Connect to 24V DC power supply according to supplied wiring
diagrams.
Straight
Channel
Notched
Channel
Mounting
Clip