Use and Care Manual

7
Illustration #1 Illustration #2
To Install Your Wine Co oler
This wine cool e r i s designed for free standing or built-in (fully rec e ssed) installation .
Place your wine cooler on a solid and level floor that is strong enough to support it when it is
fully l oaded. This will ensure a vibration-free and noise-free operat ion. Adjust the leveling
legs in and out to stabilize the cooler horizontally. If the legs are not prop e rly adjusted, the
cooler may be unstable and result in excess noise or vibration.
Locate the wine cooler away from direc
t sunlight and sources of heat (stove, heater, radiator,
etc.). Direct sunli ght may affect the acrylic coating and heat sources may increase electrical
consumption. Extremely cold ambient temperatures may also cause the coole r not to perform
properly.
It is not advisable to install this cooler in moist areas or directly adjacent to a kitchen sink, as
moisture could cause premature corrosion to the components of your new cooler.
It is recommended you install the wine cool
er in a place with temper atures above 60°F
(15°C) and below 90°F (32°C), and humidity is under 60%. If the ambie nt temperature is
above or below recommended temperatures, the performance of the cool e r may be affected.
Placing your cooler in extremely cold or hot conditions may cause interior temperatures to
1 Gasket
2 Screw
3 Screw Driver
4 Handle