Manualshelf

Use and Care Manual

ManualsBrandsTITTLA ManualsAppliances23.54 in Dual Zone Cellar Cooling Unit in Silver 154-Wine Bottles Two Shapes of Door Handles Removable Shelves Blue LEDs
12345678910
6
INSTALLATION INSTRUCTIONS
Before Using Your Wine Cooler
Remove the exterior and i nterior packaging.
Check to be sure you have all o f the following parts:
o
14 Shelves
o
Stainless Steel Handle
o
Instruction Manual
o
2 Extra Screws for Installing Handle
IMPORTANT: Before connecting this wine cooler to a powe r source, le t it stand upright for
approximately 24 hours. This will reduce the possibility of a malfunction in the cooling
system from handling during transportation.
Clean the inter ior surface with lukewarm water usi
ng a sof
t cloth.
Install the handle on the lef t side of the door.
To Install Stainle ss Steel Handle
1) Pull away the door gasket in the area where the handle is to be installed , as Illustration #1.
The gasket is easily removed by hand, no tools are necess ary.
2) Align the handle with the pre-installed screws on the door frame. Tighten the screws with a
screwdriver until the handles secure tightly against the door frame, as Illustration #2. (Do NOT
over tighten as this will cause dam
age to t
he handle assembly).
3) Replace the door gasket to its original position.
Note: T hi s wine cooler i ncludes stainless steel handles that are not required to operate this wine
cooler. If you choose not to use the handle supplied, simply follow step 1 to access the
pre-installed screws and remove them and then place 2 decorative plugs (NOT included) i nto the
two holes separately. Continue on to step 3 to replace the door gaske t to its original position.
-
-
-
-
-